Haase Energy Tank Specifications

Standard version has three heat exchangers
Interior of tank requires no screw connections or adapters
Individual interior parts are closely laminated at the place of set up
Usable heat sources include solar collectors, solid fuel boilers, alternative fuel boilers, oil burners, heat pumps and Block Type Thermal Power Station
Heat exchangers are factory pre-installed
Heat exchangers are selected by energy input and output and are wound into “heat exchanger columns”
Heat exchangers work with the instantaneous water, meaning no long retention time for the system
Water surrounding the heat exchangers stays pressure free

Specifications

The stainless steel heat exchangers are selected by energy input & output and then wound onto so-called “heat exchanger columns”, which have a maximum outside diameter of 27”/68cm and are factory pre-installed.

The height of the heat exchanger column depends on the height of the respective energy tank. According to the performance requirements and the energy tank size several heat exchanger columns can be used.

The standard heat exchangers are:

Solar heat exchanger for heat storage
Heater and/or reheating heat exchanger to heat storage (heat sources: Oil and/or gas heating, solid fuel heating etc.) and heat emission for heating purposes
Water heat exchanger for the heating up of hot water and Drinking water

All heat exchangers, in each case with pre and return pipe, come through the cover and the insulation of the energy tank to outside lid and are ready for installation with the 1 ½ inch industrial union screw connection. Special seals, which are liquid and vapor proof, will prevent unwanted heat discharge from the energy tank.

The heat exchangers works with the instantaneous water heat principle. This means no long retention time for the system, particularly for drinking water this is hygienically the best heating solution.

The interior container of the HAASE energy tank consists of temperature-steady and 100% non-corrosive GRP (glass-fiber reinforced plastic). The individual parts interior - coat and - covers are closely laminated at the place of set up.